Quick assessment methodology for reliability of solder joints in ball grid array (BGA) assembly—Part I: Creep constitutive relation and fatigue model

In this study, a new unified creep constitutive relation and a modified energy-based fatigue model have been established respectively to describe the creep flow and predict the fatigue life of Sn−Pb solders. It is found that the relation successfully elucidates the creep mechanism related to current constitutive relations. The model can be used to describe the temperature and frequency dependent low cycle fatigue behavior of the solder. The relation and the model are further employed in part II to develop the numerical simulation approach for the long-term reliability assessment of the plastic ball grid array (BGA) assembly. The project supported by the National Natural Science Foundation of China (59705008)     

中心集中力作用下圆薄板的固有频率—载荷特征关系

本文讨论了中心集中静载作用下圆薄板在非线性弯曲静平衡构形附近的微幅自由振动,其静平衡问题采用问题的精确解在此基础上,用伽辽金法获得了其最低固有频率——载荷特征关系.所得结果可供这类谐振弹性元件设计中参考.     

损伤弹性材料的有效模量及本构关系

考虑了微裂纹之间的相互作用，利用随机熔断丝网络（Ｒａｎｄｏｍｆｕｓｅｎｅｔｗｏｒｋ）作为模型，模拟了脆性材料在外载荷作用下，其有效模量随损伤的演变行为，并考察了系统含损伤的本构关系。发现在损伤初期，有效模量和损伤具有线性下降关系；而在后期，由于损伤局部化，有效模量迅速下降，提出了一个有效模量随损伤变化的非线性关系。讨论了利用网络模型来研究材料含损伤本构关系的可行性和优越性。     

Identification de la relation de dispersion dans les barresIdentification of the dispersion relation in rods

Dispersion and attenuation of longitudinal waves in elastic or weakly viscoelastic rods are measured by analysing the resonant frequencies present in the strain spectrum due to an unknown loading. The method takes the finite measuring time of the test into account. It is applied to an aluminium bar, in which the dispersion relation is identified very accurately at frequencies up to 60 kHz. To cite this article: R. Othman et al., C. R. Mecanique 330 (2002) 849–855.     

Parameter identification for viscoelastic materials

Starting from the general stress-strain relation for a linear Boltzmann-Volterra material, which is in agreement with the principle of inertia, a new identification procedure is proposed. Instead of running one long-range relaxation experiment, following asingle suitably specified deformation history, material characterization is done using the data ofn short relaxation experiments followingn different deformation histories. To interpret these data a direct non-iterative algorithm has been developed. Compared with other methods, for example curve fitting by using Gauss' method, this direct method is numerically stable and allows a simple direct evaluation of the error due to the scattering of experimental data. The method has been applied to the determination of the relaxation times of an unsaturated polyester material.     

铝-锂合金动态扭转实验研究

利用霍普金森扭杆（Torsional Split-Hopkinson Bar）技术对三种不同成份或状态的铝-锂合金材料的动态应力-应变-应变率关系进行了实验测定。应变率范围由1300s-1到2600s-1,研究表明随着应变率的提高,三种不同成份或状态的铝-锂合金材料的韧性和强度都有不同程度的提高。对剪切带的初步观察发现,随应变率的增加,剪切带有变窄的趋势。     

On kinetics of hysteresis

An initiation criterion and a kinetic relation describing hysteresis in shape memory alloys consistent with non-equilibrium thermodynamics are proposed. The initiation of phase transition begins always at zero driving force, defined as the negative derivative of free energy with respect to the volume fraction of high strain phase. The kinetic relation is obtained from the dissipation potential which is proportional to the magnitude of the volume fraction rate times the newly formed volume fraction. The proposed theory turns out to be rate-independent, but history dependent, and can describe all features of hysteresis loops observed in experiments.      

静载荷作用下柔韧圆板的大幅度振动

本文首先给出了均布载荷作用下柔韧圆板的大幅度振动方程，按文中给出的时间模态假设导了该问题的非线性耦合的代数和微分特征方程组，利用修正迭代法求出了该方程组的近似解析解，得到了柔韧圆振动的幅频－载荷特征关系，讨论了静载荷对其振动性态的影响。     

NONLINEAR VIBRATION OF CIRCULAR SANDWICH PLATES UNDER CIRCUMJACENT LOAD

Based on von Karman plate theory, the issue about nonlinear vibration for circular sandwich plates under circumjacent load with the loosely clamped boundary condition was researched. Nonlinear differential eigenvalue equations and boundary conditions of the problem were formulated by variational method and then their exact static solution can be got. The solution was derived by modified iteration method, so the analytic relations between amplitude and nonlinear oscillating frequency for circular sandwich plates were obtained. When circumjacent load makes the lowest natural frequency zero, critical load is obtained.     

ELASTIC－PLASTIC CONSTITUTIVE MODELS BASED ON THE MULTIPLICATION PROCESSES OF DEFORMED GRAINS

（何宗彦）ＥＬＡＳＴＩＣ－ＰＬＡＳＴＩＣＣＯＮＳＴＩＴＵＴＩＶＥＭＯＤＥＬＳＢＡＳＥＤＯＮＴＨＥＭＵＬＴＩＰＬＩＣＡＴＩＯＮＰＲＯＣＥＳＳＥＳＯＦＤＥＦＯＲＭＥＤＧＲＡＩＮＳ￥ＨｅＺｏｎｇｙａｎ（ＤｅｐａｒｔｍｅｎｔｏｆＥｎｇｉｎｅｅｒＭｅｃｈａｎｉ...